Skip to content

SOLIDWORKS PCB Rookie Camp Part IV: Wire or Bus Entry

PCB Training Camp Part 4

The road through past NFL playoffs brought about an all-new buzzword, Run-Pass Option, or RPO. RPO was a part of the most memorable play, the “Philly Special.”

SOLIDWORKS PCB also gives YOU a winning formula by giving you OPTIONS when entering a bus! A bus carries multiple signals on a single line to help keep your drawings clean and concise. I use two options when adding a signal to a bus, and either entry method will allow you to get your signals where they need to go with added flexibility to move around later as needed!

SEE THE SOLIDWORKS PCB BUS ENTRY IN ACTION

Share

Meet the Author

Evan Stanek

Evan Stanek

Evan has over 10 years of experience as an Electrical Applications Engineer. Prior to GSC, he worked as an engineer in the broadcasting field designing panel layouts and schematics/installations for transmitter control systems, as well as network and control layouts for radio studios. Evan is a certified SOLIDWORKS Electrical Trainer and Electrical Applications Engineer (CSWE).

view all posts by Evan Stanek

Most Popular

Upcoming Events

Thu 17

SOLIDWORKS Visualize

October 17 @ 8:30 am - October 18 @ 4:30 pm
Germantown WI
Mon 21

SOLIDWORKS Essentials

October 21 @ 8:30 am - October 25 @ 4:30 pm
Germantown WI
Wed 23

Simulation Premium: Dynamics

October 23 @ 8:30 am - October 24 @ 4:30 pm
Germantown WI
Mon 28

SOLIDWORKS Electrical – Schematic

October 28 @ 8:30 am - October 30 @ 4:30 pm
Oakbrook Terrace IL
Mon 28

SOLIDWORKS Sheet Metal

October 28 @ 9:00 am - October 31 @ 11:00 am
Scroll To Top